Installation Instructions

Step 9: Install the transformer
Find the 10/32” hex nuts and washers in your
hardware bag.
Find the small elements between the reflector
booms. These elements have posts at their
bases.
Place two washers on each post. Then position
the transformer leads between the two washers
as shown here.
Transformer
Post
Transformer
lead
Finally, tighten the hex nuts to secure the leads.
Step 10: Insert end caps
Insert the plastic end caps in the ends of the
booms as shown here. Use a rubber mallet to
gently tap them into the antenna booms to
secure them.
Step 8: Attach the mast clamp insert
Find the U-bolt and mast clamp insert (see
the illustration to the left). Put the U-bolt
into the mast clamp insert with the teeth of
the mast clamp insert facing the closed end
of the U-bolt.
Insert the U-bolt into the mast clamp on
the antenna and loosely thread the 1/4”
hex nuts onto the U-bolt. The teeth on
the mast clamp and the teeth on the insert
should be facing the same direction.
Do not tighten the hex nuts yet.
Mast
clamp
U-bolt
Mast clamp insert