Instruction Manual
RF Exposure / Compliance Information
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
ISED Compliance statement
This device complies with ISED license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause
undesired operation of the device.
www.RCACommunicationsSystems.com
Le présent appareil est conforme aux CNR d’ISED applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en
WARNING: Under ISED regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by ISED. To
reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication. The transmitter antenna gain shall not exceed 0
dBi.
FRENCH: Conformément à la réglementation d’ISED, le présent émetteur radio peut
fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour
l’émetteur par ISED. Dans le but de réduire les risques de brouillage radioélectrique à
l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que
la puissance isotrope rayonnée quivalente (p.i.r.e.) ne dépassepas l’intensité nécessaire à
l’établissement d’une communication satisfaisante.
Please refer to the following websites for more information on what RF energy exposure
is and how to control your exposure to assure compliance with established RF exposure
limits. http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01904.html http://www.ic.gc.ca/eic/site/
ceb-bhst.nsf/eng/h_tt00080.html
Important Safety Information
Attention: This radio is restricted to Occupational use only. Before using the
radio, read the RF Energy Exposures and Product Safety Guide for Portable Two-
Way Radios which contains important operating instructions for safe usage and
RF energy awareness and control for Compliance with applicable standards and
Regulations.
For a list of RCA Communications Systems approved antennas, batteries, and
other accessories, visit the following website:
https://www.rcacommunicationssystems.com