User's Manual

Embedded mounting 

Cut a hole into the instrument panel (or wherever you plan to mount the 1.

transceiver).

Slide the transceiver through the holes as shown below.2.

Attach the clamps on either side of the transceiver with 2 supplied bolts. 3.

Tighten the end bolts on the clamps so that the clamps press ﬁ rmly against 4.

the inside of the instrument control panel.

Antenna connection



Please connect an antenna before transmitting. Select the antenna with the relative

frequency and connect on the ANT antenna connector. Use the antenna and low

loss concentric with the same natural impedance 50Ω.

Transmitting without an antenna may damage the trans- 

ceiver.

Connections



After connecting the DC power cable, GPS receiver lead and external speaker lead,

cover the connector and leads with an adhesive tape as below, to prevent water

seeping into the transceiver.