User's Manual

5
Turn ON/OFF

Press1. [ ] for 1 second to turn ON.
Press again2. [
]for 1 second to turn OFF.
Adjusting the Volume Level

The volume level can be adjusted using [VOL/SQL] and [▼] or [▲].
Push 1. [VOL/SQL] once to enter the volume adjustment mode. Then
press [▼] or [▲] to adjust the volume level.
The"VOL" icon starts blinking. 
The transceiver has 31 volume levels and OFF. 
When no key operation is performed for 5 seconds, then transceiver 
returns to the normal mode.
Push2. [VOL/SQL]twice to exit the volume adjustment model.
Adjusting the Squelch Level

The squelch level can be adjusted using [VOL/SQL] and [▼] or [▲] . in the
order to properly receive signals. As well as for the scan to effectively func-
tion, the squelch must be adjusted to the proper level.
Push 1. [VOL/SQL] twice to enter the squelch adjustment mode, then
push [▼] or [▲] to adjust the squelch level.
The"SQL" icon starts blinking. 
The transceiver has 11 squelch levels: OP is completely open;10 is 
tight squelch; 1 is loose squelch
When no key operation is performed for 5 seconds, the transceiver 
returns to the normal mode.
push 2. [VOL/SQL]again to exit the squelch adjustment mode.
BASIC OPERATION
Receiving and Transmitting

Receiving 
set the volume levels by push 1. [VOL/SQL] , [▼] or [▲].
set the squelch levels by2. [▼] or [▲].
when receiving a signal, " 
" appears and audio is heard from
the speaker.
The conserve battery power, the transceiver's power save function 
automatically activates when no signal is received for 5 seconds.
Transmitting 
Push 1. [Hi/Lo] to select output power.
"LOW"appears when low power is selected. 
Choose low power for short range communications; choose high 
power for longer distance communications.
Some channels are for only low power communication. 
Hold down 2. [PTT] to transmit, then speak into the microphone.
"TX"appearks. 
Channel 70 cannot be used for transmission 
Release 3. [PTT] to receive.
NOTE:
Transmitting without an antenna can damage the transceiver. 
To maximize the readability of your transmitted signal, pause for a 
second after pushing 【PTT】hold the microphone 5-10cm from your
mouth and speak into the microphone at a normal voice level.
Channel Group Selective

This transceiver is pre-programmed with USA.International,Canadian chan-
nels.Choose the appropriate channel groups for your operating area.