User's Manual

8
Scan Types

Scanning is an efficient way to locate signals quickly over a wide frequency
range. The transceiver has priority scan and normal scan.
In addition, the weather alert and auto scan functions are available for stand-
by convenience. These functions can be activated simultaneously, depend-
ing on the setting in set mode.
NormalScan
It searches through all TAG channels in sequence.However, unlike priority
scan, Channel 16 is not checked unless channel 16 is set as a TAG channel.
Priority Scan
A priority scan sequentially searches through all TAG channels while moni-
toring Channel 16. when a signal is detected on Channel16, the scan pauses
until the signal disappears; when a signal is detected on a channel other than
Channel 16, the scan switches to Dualwatch, until the signal disappears.
Setting TAG Channels

For more efficient scanning, set the desired channels as TAG channels or
clear the TAG setting from unwanted channels. Channels that are not tagged
will be skipped during scanning.
SCAN OPERATION
Setting (or clearing) a TAG channel 
Push 1. [CH] to select desired channel group.
Push 2. [▼] or [▲] to select the desired channels to be set as a TAG
Channel.
Push and hold " 3.
" for 1 second. to set the displayed channel as
a TAG Channel.
" 
" appears in the function display.
To cancel the TAG channel setting, push and hold " 4.
" for 1sec.
" 
" disappears.
Setting (or clearing) all tagged channels 
While pushing and holding 1. [TAG], turn power [ ] ON to clear all
TAG channels in the selected channel group.
Repeat above procedure to set all channels as TAG channels.2.
Starting a Scan

Set the priority scan function, scan resume timer and auto scan function is
advance, in the set mode.
Push 1. [SCAN] to start normal scan or priority scan.
"SCAN" Blinks. 
"16" appears on the sub channelreadout during a priority scan. 
When a signal is received, the scan pauses until the signal disap- 
pears, or resumes after pausing 5 seconds, depeneding on the set
mode setting.
Push  [▼]or[▲] to sequentially select TAG channels, change the
scanning direction or manually resume the scan.
Pus2. [SCAN]to stop the scan, or push [PTT],[16/C], [CH]or[FAV]also
can strops the scan.