1-18 Gelande II Manual

RC4WD 1/18 Gelande II RTR Truck
28
XR2 Ultimate Micro ESC/Receiver
1. ESC/Receiver Features
Type 2.4GHz RX with Crawler ESC
Servo Port
Standard 3 Pin Servo Port
BEC For Servo 5V,1A
Battery 7.2V NiMH or 2S LiPo, JST connector (Use setup key to select battery type)
2. ESC/Receiver
Status
LED Remark
LED Off: If after 4 sec with no TX
detected, it will flash 2 times repeatedly
to indicate loss of signal.
TX Off
Normal Operation: LiPo Mode
Normal Operation: NiMH Mode LED Flashing Quickly
LED Solid On
To select battery type, See section 3
To select battery type, See section 3
3. Selecting Battery Type
During normal operation, hold the key for 5+ seconds until LED change status. Now battery type is changed and
saved in the memory.
4. Electrical Specifications
Description
Specifications
Low Voltage Cut-off (NiMH) 4V (Motor will stop once battery voltage below this value)
Low Voltage Cut-off (LiPo)
6.6V (Motor will stop once battery voltage below this value)
Max Battery Voltage
9V
Max Continuous Current
Max Peak Current
Thermal Protection
Stall Protection
3.5A
6A
By current limit – 3A
BEC 5V, 1A with Thermal and Over Current Protection
XR2 Ultimate Micro Radio
1. Transmitter Features
Type
2.4GHz, Frequency Hopping, FHSS
2 Channel System
Programmable Steering End-points by Setup Key
Programmable Throttle End-points by Setup Key
Adjustable Steering Trim
Adjustable Throttle Trim
Dual Rate Steering
Low Battery Indicator LED