Recommended Tools Hex Drivers (1.
Warranty RC4WD non-electrical products are warranted to be free of defects in materials and workmanship when new. Our limited warranty does not cover damages due to normal wear and tear, user error of assembly or installation, user modifications, user's failure to perform routine maintenance, addition of aftermarket parts or option parts. This warranty lasts 30 days after arrival for original purchaser.
BATTERY CHARGING Do not leave battery and charger unattended 1. Only change batteries that are cool to the touch and are not damaged (swollen, bent, broken or punctured). 2. Connect the charger to the proper wall receptacle noting proper polarity. 3. Plug the battery’s connector into the charger’s connector. The LED will light red as it is charging. 4. The charger will emit a tone and the LED will change to green once fully charged.
Failure to follow instructions associated with this symbol risks injury or even death! Avoid battery liquid contact with skin and clothing. If contact occurs, remove contaminated clothing and wash skin thoroughly with water. Before Use: Read and understand the battery and charger operating instructions before recharging. NEVER place a battery into water. ONLY use genuine charger unit for recharging brand LiPo batteries.
XR2 Micro Radio Step 1. Transmitter Battery Low Indicator TH Reverse SH Reverse TH D/R SH D/R 2.
XR2 Micro Radio Step 4. Binding the Transmitter and Receiver Turn on the receiver power. Press the SW switch. The receiver’s LED should start flashing. Turn on the transmitter. When the LED on the receiver becomes solid, the binding process is completed. Step 6. Transmitter Adjustments A. Throttle Trigger B. Steering Wheel Neutral Slow Down/ Reverse Left Speed Up Right Neutral 1. Push the trigger to the center position to stop. 2. Pull the trigger back to accelerate. 3.
1/18 Gelande II Scale RTR Truck Electronic Manual This is a step-by-step overview of your new truck's electrical items and how they connect. 1. Outcry II ESC (Z-E0078) 2.
3. Connect motor to motor plug 4.
5. Shows the battery (Z-E0080) connected to the ESC 6.
Time to get your new truck setup and running If you have a Black Rock, look below. If you have a BlackJack, turn to Page 14. If you have a D90, turn to Page 18. Step 2. Read the instructions Step 1. Remove all items from box Carefully remove all items from the box. Take care when pulling the truck from its tray as it may damage it. Be careful when removing the truck as it can easily fall out of the packaging.
Step 7. install the Battery Step 6. Turn on the transmitter Install your new RC4WD 850 mAh battery pack using the included velcro strap. ON Step 9. Turn the switch to ON Step 8.
Step 11. Reinstall the body Step 10. Transmitter Adjustments Get familiar with the steering and throttle.
Replacement Parts RC4WD 7.4V 850mAh 2S LiPo Battery (Z-E0080) Rock Crusher 1.0" Micro Crawler Tires (Z-T0027) 2-in-1 Micro ESC + Receiver for XR2 Micro Radio (Z-E0078) 9G Analog Metal Gear Micro Servo (Z-E0077) RC4WD 1/18 Black Rock Body Set (Z-B0113) Stamped Steel 1.0" Stock Beadlock Wheels (Black) (Z-W0229) Punisher Shafts 1/18 (42mm - 50mm / 1.57" - 1.
Time to get your new truck setup and running Step 1. Remove all items from box Step 2. Read the instructions Carefully remove all items from the box. Take care when pulling the truck from its. tray as it may damage it. Be careful when removing the truck as it can easily fall out of the packaging. Remove the battery and charger and read through the charging instructions as the battery will need to be charged before you can use your new truck. Step 4. Installing the Batteries Step 5.
Step 7. install the Battery Step 6. Turn on the transmitter Install your new RC4WD 850 mAh battery pack using the included velcro strap. Step 9. Turn the switch to ON Step 8.
Step 11. Reinstall the body Step 10. Transmitter Adjustments Get familiar with the steering and throttle.
Replacement Parts RC4WD 7.4V 850mAh 2S LiPo Battery (Z-E0080) Dirt Grabber 1.0" Micro Crawler Tires (Z-T00142) 2-in-1 Micro ESC + Receiver for XR2 Micro Radio (Z-E0078) 9G Analog Metal Gear Micro Servo (Z-E0077) RC4WD 1/18 Black Rock Body Set (Z-B0113) Stamped Steel 1.0" Stock Beadlock Wheels (White) (Z-W0111) Punisher Shafts 1/18 (42mm - 50mm / 1.57" - 1.
Time to get your new truck setup and running Step 2. Read the instructions Step 1. Remove all items from box. Carefully remove all items from the box. Take care when pulling the truck from its tray as it may damage it. Be careful when removing the truck as it can easily fall out of the packaging. Remove the battery and charger and read through the charging instructions as the battery will need to be charged before you can use your new truck. Step 4. Installing the Batteries Step 5.
Step 7. install the Battery Step 6. Turn on the transmitter Install your new RC4WD 850 mAh battery pack using the included velcro strap. ON Step 9. Turn the switch to ON Step 8.
Step 11. Reinstall the body Step 10. Transmitter Adjustments Get familiar with the steering and throttle. Steering Wheel Throttle Trigger Go create an adventure and share it with us. Make sure to use @rc4wd on Facebook and hashtag #rc4wd on Instagram.
Replacement Parts RC4WD 7.4V 850mAh 2S LiPo Battery (Z-E0080) Rock Crusher 1.0" Micro Crawler Tires (Z-T0027) 2-in-1 Micro ESC + Receiver for XR2 Micro Radio (Z-E0078) 9G Analog Metal Gear Micro Servo (Z-E0077) RC4WD 1/18 Blackjack Body Set (Z-B0126) Stamped Steel 1.0" Stock Beadlock Wheels (Chrome) (Z-W0263) Punisher Shafts 1/18 (42mm - 50mm / 1.57" - 1.
Optional Parts Rock Crusher 1.0" Micro Crawler Tires (Z-T0027) Rok Lox 1.0" Micro Comp Tires (Z-T0028) Rage 1.0" Beadlock Wheels (Z-W0061) RC4WD Mickey Thompson Baja Claw TTC 1.0" Micro Crawler Tires (Z-T0067) RC4WD Interco Super Swamper TSL/Bogger 1.
www.rc4wd.com 618 Blossom Hill Rd. Ste. 201 San Jose, CA 95123 Web: www.rc4wd.com - Email: support@rc4wd.
