LWB Trail Finder 2 RTR manual

RC4WD
TF2 LWB RTR
viii
W
ARNING: Prior to proceeding, be sure to either remove the pinion from the motor or elevate the truck so the wheels are
not
able to touch the ground.
1.
The CPU can automatically sense if it is at its center point. Keep the switch at “ON” after connecting with power
, motor will
emit a “DO” sound and start the center point learning process.
2. During this time, please do not touch the throttle. If the center point is reached, motor will emit a “DO RE MI” sound. If the
center point is not reached, motor will emit a ”DO DO…” sound. If this happens, user must manually adjust to center point.
User should hear the motor go from emitting “DO DO…” sound to emitting ”DO RE MI” sound.
That’
s the center point learning
process.
3. If the ESC is unable to receive the signal, LED light will flash very quickly to alert user that there is no signal.
INSTRUCTIONS
Product Features and Characteristics
I. NiMH/Lipo Option
II. Drag Brake/Standard Option
III. Micro Controller (MCU) Automatic Learning Center Point
A. This ESC will automatically determine if it’s 2S or 3S, no human operation is required. Once connected to the power and
the center point learning is completed, motor will emit a sound of battery quantity. For example, “MI MI” is for 2S, “MI MI MI”
is
for 3S.
B. This ESC will protect the lithium battery to avoid the battery from extreme discharge.
C. This ESC has an LED voltage warning. LED light will indicate a slow flashing when the lithium battery is being protected.
D. This ESC has a half-power warning. When using 2S battery, if the voltage goes down to 6V, ESC will start the half-power
output. If the voltage goes down to 5.8V, ESC will stop working. When using 3S battery, if the voltage goes down to 9.6V, ESC
will start the half-power output. If the voltage goes down to 9V, ESC will stop working.
IV. Automatic Temperature Protection
The automatic temperature protection can prevent ESC from any damages caused by overheating. This product has a special
design for temperature control. When the temperature is very high, the ESC will stop power itself off and the LED light will
stay on as a warning.
V. While in the lithium battery mode, the battery quantity will be automatically recognized.
IMPOR
TANT NOTES
1. Prior to proceeding, be sure to either remove the pinion from the motor or elevate the truck so the wheels are not able to
touch the ground.
2.
Do not touch this product while in use to avoid injury
. Product emits heat and thus, the heat sink may become extremely hot.
3.
This product is waterproof. Product will be functional in up to 10cm of water for 2 hours.
NiMH
Lipo
DRAG BRAKE ST
ANDARD
BAT T BAT T
TYPE TYPE