Operating instructions
6
- has been subjected to any serious transport-related stresses.
> Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
Before commissioning
> Regularly check the functional reliability of your model and the remote control system. Watch out for any
visible damage such as defective plug connections or damaged cables.
> All moving parts of the model must run smoothly but should not have any play in their bearings.
> Check before each operation the correct and secure position of the propellers.
> The ight battery required for operation must be charged according to these operating instructions.
> Ensure sufcient residual capacity (battery tester) of the batteries inserted in the transmitter. If the
batteries are empty, always replace the complete set, never individual cells only.
> Always switch on the remote control (transmitter) rst. Please ensure that when you turn on the
transmitter the throttle control is set to the lowest setting (motors off)! Then the ight battery of the model
may be connected. Otherwise, unexpected reactions of the model may occur and the rotors might run
unintentionally!
> When the rotors are running, make sure that neither objects nor body parts are in the rotating and
suction area of the propellers.
During Operation
> Do not take any risks when operating the model! Your own safety and that of your environment is solely
down to you being responsible when dealing with the model.
> Improper operation may cause serious injury and property damage! Therefore make sure to keep a
sufciently safe distance to persons, animals or objects during operation.
> Select an appropriate location for the operation of your model.
> Fly your model only if your ability to respond is unrestricted. The inuence of tiredness, alcohol or
medication can cause incorrect responses.
> Do not direct your model towards spectators or towards yourself.
> Motor, electronics and ight battery may heat up during operation of the model. For this reason, wait for
5 to 10 minutes before recharging or replacing the ight battery.
> Never switch off the remote control (transmitter) while the model is in use. After landing, always
disconnect the ight battery rst. Only then may the remote control be switched off.
> In case of a defect or a malfunction, remove the problem before using the model again.
> Never expose your model or the remote control to direct sunlight or excessive heat for an extended
period of time.
> In the case of a severe crash (e.g. from a high altitude) the electric gyro sensors can be damaged and/or
misadjusted. Therefore, full functionality must be tested before ying again without fail!
> In the event of a crash, the throttle should be immediately reduced to zero. Rotating propellers may
be damaged if they come into contact with obstacles. Before ying again, these should be checked for
possible tears or breakages!