Operating instructions
42
20. RC EYE ONE S PRELIMINARY RELEASE NOTES
Changes from previous version (from ‘RC EYE One’ to ‘RC EYE One S’):
> TX/RX 2.4 GHz with frequency hopping (Automatic channel selection).
> TX with xed timer function.
> TX available in Mode 1 and Mode 2.
> New landing gear (Motors are now free above ground).
> Enhanced motor blocking recognition: Motors will be checked and switched off when motor current
differs excessive 2 seconds after power-up. Motors will be switched of when a short circuit at any of the
motors is detected (*!).
> Stronger driver MOSFET for motors.
> 25% increased power in SPORT mode. Angle boundary remains unchanged in SPORT mode.
> Wobble risk minimized. The copter does not tend to start swinging after fast descending with low motor
power.
> Angle-zero-set 2 seconds after reducing power to 0: This allows the user to reduce throttle to 0 while
ying for up to 2 seconds.
> Flight mode switchable via TX only (Former CHANNEL select switch).
> Semi automatic acrobatic mode.
(*!): Each time you start to y the “RC EYE One S”, the rmware will check the current ow to each motor.
If a motor requires an unusual high amount of power (current ow), all motors will be switched off for safety.
You will not be able to use the product until you have identied and replaced the faulty motor. A motor may
draw excessive amount of power because it has reached its end of life or because it has been damaged,
e.g. a bent shaft or any other damage to the motor including its propeller.
<a>Last_English