Operating instructions
34
12. BINDING 2.4 GHZ TX AND RX
Before you start binding your TX and RX make sure that you have installed the AAA batteries into the
2.4 GHz transmitter.
1. Install ight battery into your RC EYE One S and connect the battery. The RC EYE’s status LED should
go solid green.
2. Press and hold the ‘bind button’ of the RC EYE One S located next to the battery tray until the status
LED starts to ash red/green.
3. Make sure that the throttle stick is at full zero. Turn the transmitter on (two beeps), turn it off (one beep),
press and hold the ON/OFF button again until you hear a beep sound every 3 seconds. You are now
in binding mode.
4. Wait until the RC EYE’s status LED ashes in the corresponding color related to the selected ight mode
indicating that the binding process has been completed. You need to perform step 1. – 4. within a given
time, otherwise binding will not be successful.
5. Note: The previously known ight mode selection button (now referred to as ‘bind button’) is no longer
used to toggle between different ight modes. It is now only used to enter the binding mode!
13. 2.4 GHz FREQUENCY HOPPING – “FHSS”
The RC EYE One S transmitter and receiver are based on 2.4 GHz FHSS technology. This modulation
technique is repeatedly switching frequencies during radio transmission with the objective of minimizing
the unauthorized interception and/or jamming other transmitting or receiving devices such as cellphones,
wireless networks, remote controlled toys, virtually any 2.4 GHz operated product. This technology is
commonly referred to as “frequency hopping spread spectrum” or simply “FHSS”.
As a result, users are not required to select a specic radio channel, since this is done automatically via
FHSS. Thus users may operate this product within a geographical area side by side with additional remote
controlled products and other transmitting or receiving devices.
14. MAINTENANCE, CARE AND REPAIR
Regular Cleaning
The “RC EYE One S” is a very simple but nonetheless well-designed ying device. There are no mechanical
parts that need to be lubricated or require special maintenance. However, after each ight operation you
should clean the “RC EYE One S” of possible dirt (wool strings, dust, etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics,
rechargeable battery and motors.
Do not y without covering the electronics. Please ensure that no moisture enters the inner central piece.
Never y when it is raining!