Operating instructions
30
Before start ipping, it is required to test if all 4 motors are working perfectly. To do
so, push throttle to max while hovering. The copter should ascend straight upwards
without leaning to any direction and without turning in its rudder axis. If the copter does
not ascend straight upwards, change the motor (or only the propeller) where the copter
is leaning to while at full throttle. Perform this step repeatedly until the copter climbs
straight upwards. To prevent injury and property damage always re-perform this test
after a crash or after a part replacement.
Product warranty does not include replacement of parts, compensation for property
damage of any kind, compensation for personal injury or injury to others resulting from
any ight maneuver where recommended safety guidelines have not been followed by
the pilot. You, the pilot are responsible to inspect your unit for perfect condition and
ight readiness before you attempt any kind of ight, regardless whether acrobatic ight
maneuvers or casual ight.
It is strongly recommended that you perform a full visual inspection each time before
you attempt a ight and each time you have encountered a crash, regardless if minor or
major crash. Observe the condition of each motor, its motor shaft, its wire connections
and its propeller position and propeller condition. Always replace defective parts
immediately. If you are unsure about your products condition consult an experienced
RC pilot or contact customer support at contact@rclogger.com immediately. Do not
attempt any further ight until you have conrmed your products condition to be ne
and t for ight.
You have been warned and you have accepted the warnings prior to using the product.
Activating acrobatic ight mode
To enable the acrobatic mode press and hold the ‘ACRO button’ while in ight.
Performing ip or roll
While pressing and holding the left front button on TX (‘ACRO button’) acrobatic mode is activated in
SPORT and EXPERT ight mode only. Status LED ashes fast while acrobatic mode is activated. After
releasing ‘ACRO button’ acrobatic mode is disabled again. When acrobatic mode is active, user can select
ip direction by pushing the nick/roll stick to any max direction. Combined ips (Combined ‘Nick’ and ‘Roll’)
are not allowed.