User manual

50 | Flying The Xtreme
18.6.5.2 EXPERT mode flip recommendation
1. Acceleratethe»Xtremeupwardsbypushingthrottletomaximum.
2. StartipbypushingAILERON(Roll)orELEVATOR(Flip)toanymaximumdirection
andreducethrottletoapprox25%.
3. As soon as the »Xtreme is back in upright position increase THROTTLE to help the
copter stabilise again.
4. Compared to the SPORT MODE motor power willonly be changed by thepilot’s
inputsandnotbythe»Xtreme.
18.7 Altitude height hold function
18.7.1 Introduction
The ALTITUDE HEIGHT HOLDfunctionletsyouholdthe»Xtremeinasetightaltitude.
The status LED + orientation LEDs flash fast while the
height hold function is enabled.
18.7.2 Activation
Theuseofthesuppliedstocktransmitterisdescribedhere.Foryourowntransmitterrefer
toitsuserinstructionsandyourowncongurationrespectively.
> AltitudeheightholdfunctionisonlyavailableinSPORT mode.
> When altitude height hold is enabled, then:
» the STATUS LEDashescontinuouslyandfast
» the ORIENTATION LEDSblinkcontinuouslyandfast
1. Activate SPORT mode.
2. Lift the »Xtreme up to the desired altitude. Keep the »Xtreme at a stable altitude.
3. Press the HEIGHT HOLD BUTTON.
4. Youmaynowythe»Xtremewithouthavingtoadjustthealtitudeviathrottleinput.
5. It is possible to use RUDDER, AILERON and ELEVATOR while this function is
enabled.PaycarefulattentionnottoaccidentallymoveTHROTTLE too much as this
will disengage the ALTITUDE HEIGHT HOLD function.
6. Todeactivatetheheightholdfunctiondecreaseorincreasethrottleslightly.