User manual
Using A Camera | 39
17. USING A CAMERA
17.1 Introduction
Youhavethepossibilitytoattachacameratothe»Xtremebyusingthe“RCLoggerAerialKit”
(89064RC).The“AerialKit”isnotsuppliedwiththe»Xtreme.However,itisdescribedhere
indetailasitisanecessaryaccessorywhenintendingtoattachacameratothe»Xtreme.
Theentirechapterwillexplaintoyouhowtopreparethe»Xtremeforusewithacamera.
Thecameratobeattachedmustbeself-sufcient.Excepted istheRCLoggercamera
“RCEYEOneCamTX”(89049RC),whichcanbesuppliedwithpowerviathe»Xtreme’s
ightbatteryandadapter(89080RC).
17.2 Aerial kit
17.2.1 Aerial kit explained
17.2.1.1 Camera tray
The“AerialKit”willmodifythe»Xtremeinsuchawaythatacameracanbeattached.
> Thesuppliedcameratrayisaplatformattachmenttowhichyoucanattachacamera
ofsuitablesizeandweight.Observechapter“12.Weightsandpayload”onpage17.
> Forinstructionsonhowtoattachthecameratray,refertosection“17.2.2Attachingthe
cameratray”onpage39.
17.2.1.2 Legs
> The supplied legs are longer than the standard ones and sufciently increase the
clearancebetweencameratrayandground.
> Forinstructionsonhowtoreplacethelegs,refertosection“17.2.3Replacinglegs”on
page 39.
17.2.1.3 Propellers
> Thestandardpropellersdonotprovideenoughlifttocarryacamera.Therefore,asetof
largerpropellershelpincreaselift,whichinturnallowforalargerpayload.
> For instructions on how to replace propellers, refer to section “19.3.1 Replacing
propellers”onpage53.
17.2.2 Attaching the camera tray
> The cameratraycanbe mounted without any further modicationonthe»Xtreme.
Carefully turn the »Xtreme upside down and place it on a soft surface. Study the
diagramsfromsection“17.3Attachingthecamera”onpage41.
> Carefully guide the traydown the guiding rods until the clips lock.Watch out! Be
sure to sufciently support the »Xtreme’s body while xing the tray so as not to
damage the legs.
> Tolaterremovethetray,releasetheclipsandcarefullypullthetrayoffthe»Xtreme.
17.2.3 Replacing legs
17.2.3.1 Direction
Mind the colour coding of the legs
Note that the RED LEGS indicate front. The BLACK LEGS indicate rear. When replacing
thelegsdonotmixthemup.
17.2.3.2 Replacement process
Toreplacethelegsasmallcross-headedscrewdriverisrequired(notsupplied).Follow
the illustration [ Fig. 22 ],whichexplainsthereplacementprocess.Donotovertightenthe
screws.