User manual

36 | Transmitter
16.4.6 Learning procedure
For your own safety, remove the propellers before you
start the learning procedure. After the test, following the
learning procedure, is passed sucessfully you may mount
the propellers again.
1. Turn on transmitter
> Switchto“H1helicopter”mode.Applynomixers.
> Make the following assignments:
» AUX-1: 3-position-switch{FLIGHT MODEselector(Beginner,Sport,Expert),
(Channel-5)}
» AUX-2: 3-position-switch{ACROBATIC mode / NORMAL FLIGHT(centre
position)/ALTITUDE HEIGHT HOLDmode(Channel-6)}
» AUX-3: 2-position-switch { TRIGGER PORT on/off (Channel-7, optional and
notrequired)}
> Before starting the learning procedure, move all switches to their off position. Move the
throttle to the lowest position.
2. Connect Flight Battery
Whenconnectingthebatterymakesuretokeepanybodypartsoutoftherotor/propeller
area.
3. Initialize learning
Press and hold the BIND BUTTON (13) on the »Xtreme until the status LED blinks one
(1)timeinredcolorindicatingChannel-1learningisactivated
4. Learn throttle (Channel-1)
> Move THROTTLEupandbacktodownagain(fulluptofulldown).
> The LED will blink red 2 times indicating Channel-2 learning.
5. Learn rudder (Channel-2)
> Move RUDDER to the left and back to centre again.
> The LED will blink red 3 times indicating Channel-3 learning.
6. Learn elevator (Channel-3)
> Move ELEVATOR up and back to centre again.
> The LED will blink red 4 times indicating Channel-4 learning.
7. Learn aileron (Channel-4)
> Move AILERON to the left and back to centre again.
> The LED will blink red 5 times indicating Channel-5 learning.
8. Learn AUX-1 (Channel-5)
> Toggle AUX-SWITCH-1(3positions)fromposition1to2to3andbackto1.
> The LED will blink red 6 times indicating Channel-6 learning.
9. Learn AUX-2 (Channel-6)
> Toggle AUX-SWITCH-2(3positions)fromposition1to2to3andbackto1.
> The LED will blink red 7 times indicating Channel-7 learning.
10. Learn AUX-3 (Channel-7)
> Toggle AUX-SWITCH-3(2positions)fromposition1to2andbackto1.
> The LED will start to blink steadily indicating that PPM learning has completed
successfully(readytotest/y).Thisstepcanbeignoredwithin5seconds.
If no input is detected learning will be completed auto-
matically and Channel-7 (AUX-3) is ignored!