User manual

Transmitter | 35
R
WBB
Capacitor
W
Fig. 18
1
2
3
Fig. 19
» W: White
» B: Black
» R: Red
2. RoutethePPMcablethroughthe lower ight control circuitboardandmainframe
towards the front orientation LED.
» To best route the wire, make use of the gap near the motor wire socket as shown
in [ Fig. 18 ].
» The cable must notobstructanycomponentsoftheuppercircuitboardasthis
mayinuenceightcontrolsensors,leadingtopoorightperformance.
3. InstallyourPPM RECEIVER withdoublesidedtapebetweenthebattery trayand
front orientation LED. See [ Fig. 19 ].
» Do notguideanyPPMreceiverwireantennasabovethebatterytray.
4. Connect the PPM cable to the PPM receiver. Observe the manufacturer instructions of
the PPM receiver for more information on pin allocation.
5. Replacethecanopy.
Once the PPM cable is in place, check if the canopy rubs
against the PPM cable when mounting it. Rubbing
damages the wire insulation, which as a consequence can
cause short-circuiting.
16.4.5 Binding
> BindthePPMreceiverwithyourtransmitter.Refertotheoperatinginstructionsofyour
transmitter and PPM receiver.
> Use7CHmodeonFutaba
®
FASSTsystems!IfnoPPMreceiverisdetected,learning
mode will not be activated!