User manual

34 | Transmitter

Fig. 16

100

Throttle

Setting

0% Low

Stick Stick High Stick

25% 50% Mid 75% 100%

Fig. 17

3. Assign the transmitter channels as following:

» Channel 1: AILERON

» Channel 2: ELEVATOR

» Channel 3: THROTTLE

» Channel 4: RUDDER

» Channel5: AUX-1 { FLIGHT MODE selector (Beginner, Sport, Expert),

3-waytoggleswitch}

» Channel6: AUX-2 (ACROBATIC mode, NORMAL ight, ALTITUDE

HEIGHT HOLDmode,3-waytoggleswitch)

» Channel7: AUX-3(Optionaltriggerport,2-waytoggleswitch)

4. Ensure to set your THROTTLE CURVE linearfromfull“0%” to “100%”.A PITCH

CURVE is not needed and must be disabled. Disable all mixing! Refer to [ Fig. 17 ].

16.4.4 Connecting and mounting the PPM receiver

WARNING!

Your PPM receiver may feature wire antennas to improve

reception. DO NEVER let the wire antennas touch the

orientation LED connections, or the main flight controller

circuit will be destroyed immediately.

16.4.4.1 Mainboard connectors

16.4.4.2 PPM cable

1. Connect the PPM receiver cable (10) to the 3-pin header connector located on the

uppermainightcontrolcircuitboardofthe»Xtreme.GROUND PIN(black)facesthe

capacitor, POSITIVE PIN(red)isincentreandtheSIGNAL PIN(white)isfacingthe

motor connector and boom. See [ Fig. 18 ]. Note the following colour codes: