User manual

32 | Transmitter
16.3.8.4 Learning procedure DX6i
1. Prepare
Turnonthe“OneLINK”,andensureitisconnectedtothetrainerportofyourDX6i.Before
startingthelearningprocedure, position all switchestotheir“0”position and movethe
throttle to its lowest position.
Notes
> TherstassignableswitchwillbetheGEARswitchduringprocess:
» Flightmodeselector(Beginner/Sport,orSport/Expert)dependingonsetup
> The second assignable switch will be the FLAP switch:
» Acrobatic Mode / Normal Flight, or Altitude Height Hold / Normal Flight
2. Initiate Learning
The ”OneLINK” will emit an audible beep indicating each
step is completed and readyness for the next step!
> Pressandholdthesecondbuttononthe“OneLINK”untilthetopstatusLEDstartsto
blinkredone(1)timeindicatingChannel-1learningisactivated.
> An audible beep will be emitted acknowledging the programming mode is enabled.
3. Learn throttle (Channel-1)
> Move THROTTLEupandbacktodownagain(fulluptofulldown).
> The LED will blink red 2 times indicating Channel-2 learning.
4. Learn rudder (Channel-2)
> Move RUDDER to the left and back to centre again.
> The LED will blink red 3 times indicating Channel-3 learning.
5. Learn elevator (Channel-3)
> Move ELEVATOR up and back to centre again.
> The LED will blink red 4 times indicating Channel-4 learning.
6. Learn aileron (Channel-4)
> Move AILERON to the left and back to centre again.
> The LED will blink red 5 times indicating Channel-5 learning.
7. Learn AUX-1 (Channel-5)
> Toggle GEARswitch(2positions)fromposition0to1andbackto1.
> The LED will blink red 6 times indicating Channel-6 learning.
8. Learn AUX-2 (Channel-6)
> Toggle FLAP/GYROswitch(2positions)fromposition0to1andbackto1.
> The LED will blink red 7 times indicating Channel-7 learning.
After a short delay a final longer tone will be emitted
indicating learning has completed successfully. Please
continue to the binding procedure described in section
“16.3.6 Binding the OneLINK to the »Xtreme” on page 29
and follow the remaining setup process.