User manual

28 | Transmitter
4. Connect interface cable
> Connecttheinterfacecable(forthiscase:microUSB/3.5mmstereojack)fromthe
transmittertothe“OneLINK”.Poweronthe“OneLINK”viathetopmostbutton(Short
press).
> Refertothesupplieduserinstructionsifnecessary.
16.3.4 Important notes in regards to learning the OneLINK
Verify all assignable switches are functioning via the
Monitor display (Visible with DX8, DX7, DX7s, and DX6i).
When toggling the assigned switches (Example for DX8:
Flap/Gyro, Aux 2 / Gov, and Gear) movement of the icon
should be observed. If the monitor icon does not move then
the channel switch is inhibited and will need to be enabled.
Toenableinhibitedswitchespleaseconsultyourtransmitteroperatinginstructions.Refer
to [ Fig. 12 ] for more information on the monitor icon movement.
Fig. 12
16.3.5 Learning the OneLINK
For your own safety, remove the propellers before you
start the learning procedure. After the test, following the
learning procedure, is passed sucessfully you may mount
the propellers again.
1. Prepare
> Turnonthe“OneLINK”.
> EnsureitisconnectedtothetrainerportofyourSpektrumtransmitter.
> Beforestartingthelearningprocedure,positionallswitchestotheir“OFF”positionand
move the throttle to the lowest position.
Notes:
> First assignable switch, toggled during process:
» FlightModeSelector(Beginner,Sport,Expert)
> Second assignable switch, toggled during process:
» AcrobaticMode/NormalFlight(centerposition)/Altitudeheightholdmode
> Third assignable switch, toggled during process:
» TriggerPortON/OFF(optionalandnotrequired)
2. Initiate learning
The ”OneLINK” will emit an audible beep indicating each
step is completed and readyness for the next step!
> Pressandholdthesecondbuttononthe“OneLINK”untilthetopstatusLEDstartsto
blinkredone(1)timeindicatingChannel-1learningisactivated.
> An audible sound will be emitted acknowledging the programming mode is enabled.