User manual

Transmitter | 27
16.3.1 Preparation
Inordertomakeuseofthe“OneLINK”optionyouwillneedtopreparethefollowingitems:
> Your own transmitter with:
» Min.6channels(7channelsarerecommended)
» Two3-way-toggle-switches
» One2-way-toggle-switch
> Note:Ifyourtransmitterdoesnotprovidetwo3-way-toggle-switchespleasereferto
theworkaroundexplainedattheendofthischapter(“16.3.8DX6Iwithonly2position
switch”onpage30).
> The“RCLoggerOneLINK”(includingtwoAAAbatteries)
> The suitable interface cable. Depending on your transmitter thiscablewillinterface
betweenthetrainerportofyourtransmitterandthe“OneLINK”.Thedeliverycontents
ofthe“OneLINK”includesseveralinterfacecables.Choosetheonesuitableforyour
transmitter.
Fig. 11
16.3.2 Mounting the OneLINK to your transmitter
The best and easiest application is to use some adhesive-backed hook and loop fastener.
The“OneLINK”canthenberemovedwhennotneeded.Applyasmallamountofeither
hookorlooptothebackofyourtransmitterandthe“OneLINK”.See [ Fig. 11 ].
16.3.3 Preparing your OneLINK for Spektrum transmitters
In these operating instructions, the use of the ”OneLINK”
is described in combination with Spektrum
®
transmitters.
For use of the ”OneLINK” in combination with other
transmitter brands, refer to their corresponding operating
instructions.
If using Spektrum DX6i please refer to the workaround at the
end of this chapter to enable the 6th channel (see section
“16.3.8 DX6I with only 2 position switch” on page 30).
1. Create a new model
Firstyouwillneedtocreateanewmodel(AirplanetypeisrecommendedforSpektrum
transmitters).Pleasemakesureallassignableswitchesareinthetopmostposition.Donot
changethesettingsofthetrainerfunctioninthesubmenu.Leavethissettingon“Inhibit”.
2. Turn the transmitter off
After the model is created turn off the transmitter. Once the “OneLINK” connector is
installedinthetrainerportthetransmitterwillpowerautomatically.
3. Install batteries
Install twoAAA batteriesinto the “OneLINK”. Referto the supplied user instructions if
necessary.