User manual

26 | Transmitter
16.1.3 Binding
Alsoreferto“14.QuickstartaviationTerms”onpage18forthemeaningofBINDING.
Beforeyoustartbindingyourtransmitterand»Xtrememakesurethatyouhaveinstalled
batteriesintothetransmitter.Refertosection“15.3Insert batteries into transmitter”on
page 20.
1. Move the transmitter’s throttle stick to zero.
2. Installtheightbatteryintothe»Xtremeandconnectthebattery.The»Xtremestatus
LED (9) should go solid green after a short time.
3. Press and hold the BIND BUTTON (13) ofthe»Xtreme,locatednexttothebattery
tray,untilthestatusLEDstartstoashred/green.
4. Turnthetransmitteron(twobeeps)andoffagain(onebeep)withtheON/OFF button
(6a)(7b).
5. Press and hold the ON/OFFbuttonuntilyouhearabeepsoundevery3seconds.You
are now in binding mode. Release the button.
6. Wait until the »Xtreme’s status LED ashes in the corresponding color related to
the selected ight mode indicating that the binding process has been completed.
Additionally,twoshortbeepsareemitted.
You need to perform steps 3 to 5 within a given time
(approx. 30 seconds), otherwise binding cannot succeed.
16.1.4 FHSS – Frequency hopping
> This technology is commonly referred to as FREQUENCY HOPPING SPREAD
SPECTRUMorsimplyFHSS.
> The»Xtreme’stransmitterandreceiverarebasedon2.4GHzFHSStechnology.
> Thismodulationtechniquerepeatedlyswitchesfrequenciesduringradiotransmission
with the objective of minimizing the unauthorized interception and/or jamming by
other transmitting or receiving devices such as cellphones, wireless networks, remote
controlledtoysandvirtuallyany2.4GHzoperatedproduct.
> Asaresult,usersarenotrequiredtoselectaspecicradiochannel,sincethisisdone
automaticallyviaFHSS.Thususersmayoperate thisproductwithinageographical
areasidebysidewithadditionalremotecontrolledproductsandothertransmittingor
receiving devices.
16.2 Your own transmitter
The»Xtremeallowsyoutocontrolitwithyourown2.4GHztransmitter.Youmayoperateit:
> viathe“RCLoggerOneLINK”,or
> via PPM
16.3 RC Logger OneLINK
When using the RC Logger OneLINK, turn off signal
transmission via antenna on your transmitter. Signal
should only be transmitted via the trainer port. Read
the operating instructions of your transmitter for more
information.
> The»Xtremeprovidestheoptionforuserstoaddthe“RCLoggerOneLINK”totheir
existing transmitter in order to control the »Xtreme with a standard RC transmitter
instead of the default stock transmitter.
> Onceproperlyboundtoyour»Xtremethe“OneLINK”actsasaninterfacebetweenyour
transmitter and the »Xtreme, allowing functional control.
> Refer to www.rclogger.comfortheavailabilityof“RCLoggerOneLINK”.