Instructions

Status Indication Table | 47
37. STATUS INDICATION TABLE
Type Status Trigger Front LED Rear LED Buzzer
Flight Mode Basic (ACC assisted) Channel5:(+100)
Magenta – Solid
Refertochapter”GPS” None
Altitude (Midstick height hold) Channel 5 : (0)
Green – Solid
Refertochapter”GPS” None
GPS (position hold) GPSxed-Nosignal
Blue – Blinks (fast)
Refertochapter”GPS” None
GPSxed-Poorsignal
Blue – Solid
Refertochapter”GPS” None
Channel 5 : (-100), strong GPS signal
Blue – Solid
Refertochapter”GPS” None
Flightagility
(Bank selection switch)
Channel 6 No indication No indication None
R.T.H. Return-to-Home Channel5triggeredviaswitchorTransmitter(Tx)off White–Blinkscontinuously(0.5Hz) White–Blinkscontinuously(0.5Hz) Beepbeep...pause1.5sec....beepbeep...;
Longbeepateverystepoftheprocess.
Flight Error Lowbatterylevel1 Battery<11.4V White–Blinkscontinuously(1Hz) White–Blinkscontinuously(1Hz) Continuous single beeps (1 Hz)
Lowbatterylevel2 Battery<10.5V White–Blinkscontinuously(5Hz) White–Blinkscontinuously(5Hz) Continuous single beeps (2 Hz)
Fail safe (PPM failed) Loss of RF signal White–Blinkscontinuously(0.5Hz) White – Blinkscontinuously(0.5Hz) Beep at each stage of process
Flight Check Error GPS / compass failed Start up main board self test
Red–Blinkscontinuously(1Hz) Red–Blinkscontinuously(1Hz)
None
Pressure sensor failed
Gyrofailed
Powersystemfailed
(ESC/motor)
Permanentsystemcheck Systemerror(pilotmustland!)
Red – Blinks (fast) Red – Blinks (fast)
Continuous beeps (5 Hz)
Calibration Tx Apporbuttononightcontroller
Red – Solid/ Blue – Solid (small LED) Red – Solid
None
Gyro Apporbuttononightcontroller
Green – Solid/ Blue – Solid (small LED) Green – Solid
None
Compass Apporbuttononightcontroller
Magenta – Solid/ Blue – Solid (small LED) Magenta – Solid
None
Tx Calibration in progress
Red – Solid/ Blue – Blinks (small LED) Red – Solid
Beep at each stage of the process
Gyro Calibration in progress
Green – Solid/ Blue – Blinks (small LED) Green – Solid
Beep at each stage of process
Compass Calibration in progress
Magenta – Solid/ Blue – Blinks (small LED) Magenta – Solid
Beep at each stage of process
Factorystate Gyroorcompasscalibrationprocedure Invalidgyroorcompasscalibration
Cyan– Blinks 1Hz (alternating to rear) Cyan– Blinks 1Hz (alternating to rear)
None