Instructions

Calibration | 33
5. Holdthe»NovaX350horizontallyanditsnosepointingawayfromyou.
6. Rotatethe»NovaX350twotimes(2x)aboutitslateralaxisby360°asshowninstep [1] .
7. Rotatethe»NovaX350clockwiseaboutitsverticalaxisby90°asshowninstep [2] .
Wait for a single beep.
8. Rotatethe»NovaX350twotimes(2x)aboutitslongitudinalaxisby360°asshownin
step [3] .
9. Rotatethe »NovaX350 twotimes(2x)clockwiseabout itsvertical axisby360° as
shown in step [4] .
10. Waitforconrmation:succeeded(2beeps),failed(3beeps).
11. Removethecanopy.
12. Complete the procedure.
27.8 ESC (Electronic speed controller)
ESC calibration is performed during production and does
only need to be performed again after replacing the ESC.
If you encounter problems with your ESC then our support
service may instruct you to re-calibrate the ESC. Do not
perform this calibration unless you are asked to do so.
Remove the propellers before you proceed.
ESC calibration cannot be started in calibration mode.
1. Connecttheightbatterytothe»NovaX350.
2. Removethecanopy.
3. Press and hold the PCB button until the motor driver starts to beep.
4. AfteryouhavesuccessfullycalibratedtheESC,disconnectthebattery.
5. Replacethecanopy.
1
2
180°
3
Fig. 12
1
2
3
4
Front
Rear
Fig. 13