Instructions

30 | Calibration
27.5 Learning the channels
You must reserve one 2-way-toggle-switch for the R.T.H.
(Return To Home) function. When R.T.H. is triggered it will
overwrite all settings of channel 5 (flight modes).
> Abeepconrmsasuccessfullylearnedchannel.
> Ablinkcode(e.g.1blink)indicateswhichchannelistobelearnednext.
>
Auxiliary switch: Slowlymovetheswitchthroughallpositionsandbacktoitsstarting
position.
> Assign a 3-position-toggle switch to channel 5 and channel 6.
27.5.1 Learning procedure
1. Carefullyremovethecanopy.Donotdamageanycomponent!
2. Turn the transmitter on and switch it to “H1 helicopter” mode (not applicable to
88014RC RtF) .
3. Selectanewmodelonyourtransmitter.
4. Connecttheightbattery.
5. Switch to the channel learning procedure. Refer to ‘27.3 Switching between learning/
calibration’onpage28.
6. The front large RGB LED turns solid red. The front small blue LED (on front light panel)
indicates operational status (solid = not active, blinking = active).
7. Start the calibration procedure. The blue LED starts to blink. 88014RC RtF: Observe
‘27.5.288014RC&89102RCAuxiliaryswitchassignment’onpage31.
8. Learnthe channelsaccording tothefollowingtable.Pay attentionto theLED blink
codes.
9. Complete the procedure.
LED Control Channel
3
2
1
4
MODE 1
1
2
3
4
MODE 2
3
4
1
2
MODE 3
1
4
3
2
MODE 4
1 Throttle,
2 Rudder,
3 Elevator,
4 Aileron
1 blink Throttle – Move to min. and back (mid-position) Ch 1 (mode-dependent)
2 blinks Rudder – Move to left and back Ch 2 (mode-dependent)
3 blinks Elevator – Move to top and back Ch 3 (mode-dependent)
4 blinks Aileron – Move to the left and back Ch 4 (mode-dependent)
5 blinks Flight mode selection switch (3 positions):
» Pos 1: GPS
» Pos 2: Altitude
» Pos 3: Basic
Ch 5
6 blinks Bank selection switch (3 positions):
» Pos 1: AP Mode
» Pos 2: Sport Mode
» Pos3:CustomMode(Setbypilot)
Ch 6
7 blinks Retractable legs (2 positions) Ch 7
8 blinks Gimbal control (2 positions) Ch 8
It is possible to complete the learning procedure after having
learned channel 6 by waiting for at least 8 seconds. When
using a 6-channel transmitter, a timeout function (8 seconds)
will automatically complete the learning.