Instructions

Calibration | 29
Calibrate Calibrate Calibrate
Channel learning
CompassGyro
1x
Fig. 8
27.3.2 Front LED colours when calibrating
Channel learning Gyro Compass
27.4 Binding transmitter and receiver
88014RC RtF: Receiver and transmitter were bound during
production. Proceed with channel learning.
If re-binding should become necessary at some point,
follow the given steps.
88014RC RtF: Refer to the operating instructions of the
transmitter and receiver (89102RC) for more information
on the binding and learning procedure.
> Useyourown2.4GHztransmittertocontrolthe»NovaX350;operateitviaPPM.
> Please carryout the conguration ofthe »NovaX 350 asdescribed in this chapter.
Channel learning is essential as otherwise the »NovaX 350 will not recognize your
transmitting equipment.
> Ifyouuseyourcomputerremotecontrol,programitwithoutamixerinthestandard
program.
> Basically,youcancongurethecontrolstoyourliking.However,itisrecommended
thatbeginnersfollowthegivenexamples.
> Bydefault,the»NovaX350isconguredtoMODE 2.
> If your transmitter does not provide two 3-way-toggle-switches please refer to the
workaroundexplainedin‘27.5.4 Futaba
®
transmitterswithout3-way-toggle-switch’on
page 32.
Thefollowingsectionswillguideyouthroughtheinstallationprocessandset-up.Donot
skipanysectionsastheyareinterdependent.
27.4.1 Preparing the transmitter (Tx)
1. Ensurethatallmixingisdeactivated,throttlecurvesarelinear,trimsarecenteredand
alltravelissettomaximumrange.
2. Move the throttle stick to its zero position (88014RC RtF: Make sure that the throttle
stickisinitsmid-position;thesticksarespringloadedandarecenteredbydefault).
3. Setallswitchestotheirdefaultpositions(0or1respecively).
4. Connect the supplied PPM receiver to the PPM_IN (PCB-5) and TELEMETRY
(PCB-4) port at the front of the power board.
27.4.2 Binding
> BindthePPMreceiverwithyourtransmitter.Refertotheoperatinginstructionsofyour
transmitter and PPM receiver.
>
Futaba
®
FASST systems: use the 7 channel mode.
> In the event that no PPM receiver is detected, the learning mode is not going to be activated.