Instructions

28 | Calibration
27.1 Calibrating via app or manually?
Therecommendedway to calibrate the»NovaX350 and learn thechannelsis via the
EYECONTROL app (iOS and Android). Follow the instructions given in the app. Note
[ Fig. 7 ].
If you decide for the app, only follow the in-app instructions
and directly continue with installing the propellers after
completing the calibration.
Motor start test
Completed
Manually
Learning the channels
Gyrocalibration
Compass calibration
EyeControl app
Learning the channels
Gyrocalibration
Compass calibration
Fig. 7
27.1.1 Notes on channel learning via EyeControl app
TheEyeControlapponlyguidesyouthroughcongurationofMode1orMode2.However,
itiseasilypossibletocongurethe»NovaX350asMode3orMode4,simplybygiving
different stick inputs. Read section “27.5 Learning the channels” on page 30 to learn
more.
27.2 What to do if calibration fails
Eachofthecalibrationprocedurescanfailandisindicatedby3prominentbeepsounds
(3beeps).Forexample,thetransmitterlearningprocedurefailsifyouprovidewrongstick
input. In case of failure:
1. Moveawayfrommagneticinterferences
2. Disconnecttheightbatteryandre-connectit
3. Restart the procedure.
Successfullycompletedcalibrationprocedurescanbeskipped.
27.3 Switching between learning/calibration
You do not need to perform the calibrations in sequence. All calibrations must be performed.
27.3.1 Starting and ending a calibration procedure
1. Removethecanopy.
2. Press and hold the PCB buttonontheightcontrolboardforapprox.2secondsto
put the »NovaX350intothe calibration mode. If you decide to calibrate channels,
gyroandcompassinoneattempt,thereisnoneedtorepeatthisactionbeforeeach
calibration procedure.
3. Switchtoacalibrationprocedure(channellearning,gyro,orcompass).See [ Fig. 8 ].
4. Double tap the PCBbutton(2x)tostartthecalibrationprocedure.Payattentiontothe
colourindicationsprovidedbythefrontLEDs.See‘27.3.2 Front LED colours when
calibrating’onpage29.
5. Tap the PCB buttononce(1x)tocompleteaparticularcalibrationprocedure.
6. Replacethecanopy.
Diagram [ Fig. 8 ] illustrates the functions of the PCB button: