Instructions

26 | Calibration
26.4 Installing the PPM receiver
The PPM receiver uses PPM technology. Do not confuse
PPM (Pulse-position modulation) and PWM (Pulse-width
modulation).
Study the manufacturer’s instructions supplied with the
PPM receiver and pay special attention to information/
instructions on pin allocation.
WARNING! Your PPM receiver may feature wire antennas
to improve reception. DO NEVER let the wire antennas touch
any PCB board, carbon fibre part, electrical component or
metal component. The electronic system may immediately
be destroyed!
NEVER install a PPM receiver inside the canopy!
1. Studytheinstallationdiagramsin [ Fig. 6 ].
2. Turnthe»NovaX350upsidedownandplaceitonasoftandstablesurface
[1] .
3. Loosen and remove the four nuts that hold the camera platform in place and remove
the platform [2].
4. Cut a double-faced adhesive foam pad that is half the width of and as long as the
receiver. Align and stick the foam pad along the left edge of the receiver underside.
Withtheheader pins facing up, stick thereceiveronthe »NovaX 350’sunderside.
Connect the PPM and telemetry cable to the corresponding header pins on the
receiver.
[3] .
5. Replace the camera platform and tighten the nuts
[4] .
6. Afxoneantennaoneachboom
[6] .Payattentiontothesepoints:
» Place the antennas at a 90° angle to each other. See
[5] .
» Antennas must not touch.
» Keep antennas as straight as possible.
» Keepantennasawayfromnoise(motororspeedcontroller).
» A bare antenna wire must never touch conductive (metal and carbon bre)
partsofthe»NovaX 350.Aminimum distanceof 15mm isrequiredbetween
conductive materials and a bare antenna wire.
27. CALIBRATION
Make sure you read through the entire calibration chapter
before you start calibrating the »NovaX 350.
If you fly the »NovaX 350 for the first time it is necessary to
calibrate it prior to the first take-off.
Remove the propellers before you proceed!
Only after you have successfully completed the calibration
mount the propellers again.
Calibration is divided into the following steps:
Step Chapter
1 27.4 Binding transmitter and receiver
2 27.5 Learning the channels
3 27.6Calibratingthegyro
4 27.7 Calibrating the compass
5 28. Testing the motors
6 29. Installing the propellers