Instructions

Canopy | 23
23.10 T.P.C.S
> T.P.C.Swillbeimplementedinfuturermwareversions.
> T.P.C.S or Task Point Command System differsfrom commonly known way-points,
enabling the pilot to programm a full set of tasks (e.g. a full 360° rotation) to be
completedateachdenedtaskpoint. [ Fig. 3 ] illustrates this.
> T.P.C.S is activated in and controlled through the EYECONTROL app.
TP-1
TP-2
TP-3
TP-4
TP-5
TP-6
Fig. 3
24. CANOPY
24.1 Removing
• After removing the canopy, the PCB boards are exposed.
Do not touch any electronic components. Electrostatic
discharge causes damage.
• Never remove the metal shield!
• Never use metal screws in the canopy!
Unlockthetwolocksoneithersideofthecanopyandcarefullypullitoffwithonehand.
Caution! Thereisonecableconnectingthecanopyandthemainboard.
24.2 Mounting
GPSand compass are direction-dependent.Therefore, when mountingthecanopy the
frontLEDmustpointtothe»NovaX350’sfront.
Payspecialattentiontothewiresandconnectors;donotpinchwires!Donotapplyany
forcewhenreplacingthecanopy!