Important Information 88007RC (Mode 1) 88008RC (Mode 2) 88009RC (ArF) Xtreme
1. DOWNLOAD MANUAL We regret having to inform you that the latest version of the operating instructions were not available at the time of shipment. Please download the latest version of the operating instructions from our website at www.rclogger.com. Navigate to the product page and open the ”Downloads” tab. Click on ”Operating instructions” to start the download. Fully read the operating instructions before using the product.
. SAFETY INSTRUCTIONS 3.1 Persons/Product >> The device is not a toy. Keep it out of the reach of children and pets. >> Do not leave packaging material lying around carelessly. These may become dangerous playing material for children. >> If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use.
>> Do not direct your model towards spectators or yourself. >> Motor, electronics and flight battery may heat up during operation. Wait 5 to 10 minutes before recharging or replacing the flight battery. >> Never switch off the transmitter while the »Xtreme is in use. After landing, always disconnect the flight battery first. Only then may the transmitter be switched off. >> In case of a defect or a malfunction, remove the problem before using the »Xtreme again.
3.4.2 LiPo batteries After the flight, the LiPo flight battery must be disconnected from the »Xtreme. Lithium is a highly reactive chemical element with a high energy density. In the case of overcharging, the LiPo rechargeable battery packs might catch fire or even explode. Therefore, LiPo rechargeable battery packs must always be put on a fire-proof surface for charging and the charging process must be supervised.
3.4.2.2 Total discharge >> Since discharging below 3.0 V per cell would lead to permanent damage of the rechargeable battery pack, this total discharging is to be prevented as far as possible. >> For safety reasons, programmable cruise controls/flight control systems should be set in such a way that the undervoltage detection responds already at a voltage of 3.0 V per cell (Example: 3 cells = 9.0 V cut-off voltage). Alternatively, the optical undervoltage displays are also recommended. 3.4.2.
7
www.rclogger.
