Instructions

Calibration | 25
16.5 Step 1: Channel learning
■
1xbeepconrmsasuccessfullylearnedchannel.
■
2xbeepsindicatethecompletionofthechannellearningprocedure.
■
Arm LEDs (4), (11): theblinkcode(e.g.1blink)indicateswhichchannelistobelearned
next.
■
Auxiliary switch: Slowlymovetheswitchthroughallpositionsandbacktoitsstarting
position.
Proceedasfollows:
1. Enterthecalibrationmode.
2. Press the calibration button 2x quickly to enter channel learning (if you use the
transmitterswitch‘SWB’,thisstepisnotnecessary).
3. Learnchannelsaccordingtothefollowingcalibrationandmodestables.
▬
Itispossibletocompletethelearningprocedureafterhavinglearnedchannel7
bywaitingforatleast8seconds.
4. Tapthecalibrationbuttononce(1x)toproceedtoGyroCalibration.
LED blinks Control
1x Throttle–Movetomin.andback(mid-position)
2x Rudder–Movetoleftandback
3x Elevator–Movetotopandback
4x Aileron–Movetotheleftandback
5x Flightmodeselectionswitch(3positions):
▬
Pos 1: GPS
▬
Pos 2: Basic
▬
Pos3:Expert(noautoleveling)
6x Bankselectionswitch(3positions):
▬
Pos1:Safebank
▬
Pos2:Sportbank
▬
Pos3:Racebank
LED blinks Control
7x Lostlocatorswitch(2positions):
▬
Pos1:LostlocatorOFF
▬
Pos2:LostlocatorON
8x
Cameratilt
Modes
3
2
1
4
MODE 1
3
4
1
2
MODE 3
1
2
3
4
MODE 2
1
4
3
2
MODE 4
1Throttle
2 Rudder
3Elevator
4Aileron