User manual Crack Wing RC-Factory

Rev: 2013.02.02.v001b
33
Test fit noting that the larger surface
area is the top of the rudder.
Lay down a bead of Welders on both
sides of the wing in the area that comes
into contact with the rudder. Avoid the
area directly around the servo, this will
make it easier to remove should it fail.
Spread the rudder and slide onto the
wing from the back side. Align with
the tabs and press together. Make sure
that the rudder is 90 degrees to the
wing. The glue will tack pretty quickly,
but until it does make there are no
gaps.