Installation Manual

RBP-1215B-RX3/RBP-1215SS/RX3 INSTALLATION INSTRUCTIONS
Page 5 of 6 12/2/14
RBP 13000 TEMPLE AVE. CITY OF INDUSTRY, CA 91746 800-237-7560
(Fig 11) 10mm insert tool and hex insert
(Fig 10) 09-14 driver side front mounting location
(Fig 12) Fully installed inserts
(1) 10mm Hex Bolt
(1) 10mm Flat Washer
(1) 10mm Hex Threaded Insert
Front
Front
(2) 10mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
(Fig 13) 02-08 driver side center bracket installed
Front
Rear
(Fig 14) 02-08 driver side rear modular bracket
(2) 8mm Hex Bolts
(4) 8mm Small Flat Washers
(2) 8mm Nylon Lock Nuts
Assemble tool as pictured above, (Fig 11).
Hold insert in place against body panel by
firmly grasping the handle on the tool. Turn
the hex bolt (tighten) with wrench to expand
insert in body panel. Once Metal Insert is fully
compressed, remove the bolt and tool from
Metal Insert. WARNING: Do not over-tighten
or damage to the insert may result.