Installation Manual

RBP-1215B-RX3/RBP-1215SS/RX3 INSTALLATION INSTRUCTIONS
Page 3 of 6 12/2/14
RBP 13000 TEMPLE AVE. CITY OF INDUSTRY, CA 91746 800-237-7560
STEP 8 - Line up the “L” Support Bracket with the hole in the pinch weld. Attach the bracket to the pinch weld
with (1) 8mm Hex Bolt, (2) 8mm x 22mm STD Flat Washers and (1) 8mm Nylon Lock nut, (Figures 16—19).
Leave hardware loose at this time.
STEP 9 - Repeat Steps 6—8 to attach the center and rear support brackets to the pinch weld.
STEP 10 - Align and adjust the step to the side of the vehicle. Once properly adjusted, tighten all hardware.
Tighten the 8mm hardware to 18-20ft-lbs and the 10mm hardware to 35-40ft-lbs.
STEP 11 - Repeat the above steps for the passenger side installation.
(Fig 3) 02-08 driver side mounting locations illustrated
(2) 8mm Hex Bolts
(4) 8mm Small Flat Washers
(2) 8mm Nylon Lock Nuts
Rear
Front
(Fig 4) Driver side front location pictured
Front
Remove sealing tape
(Fig 2) 09-14 driver side modular bracket installation
(Fig 1) 02-08 driver side modular bracket installation
(2) 8mm Hex Bolts
(4) 8mm Small Flat Washers
(2) 8mm Nylon Lock Nuts
Rear