Instruction Manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

Step 3

Step 4

Locate and disconnect the four (4) motor connectors from

the controller.

Using two (2) 8 mm wrenches, loosen and remove the

bolt and lock nut that holds the cable guide bracket.

Removeit.

Using a 21 mm wrench or adjustable wrench, loosen the

lock nuts from both sides of the axle. Push the wheel down

and out from the unit.

Using long needle pliers, remove the end cap from the

brake cable and save for re-installation. Using a 10 mm

wrench, loosen the lock nut that holds the brake cable in

place. Pull the cable out from the unit.

Step 5

Step 6