Owner`s manual

ASSEMBLY AND SET-UP

q Attaching the Handlebars

Tools Required: 5mm Allen wrench

q Attaching the Leg Tubes

Tools Required: 5mm Allen wrench

Place battery compartments on level surface, so leg tubes are even. You may use wedge packing material or table.

2 Center the handlebars onto the

stem. Make sure the arc on the

handlebars is facing outward and

the arc of the stem is facing inward.

3 Align the holes on the handlebar

clamp with the holes on the stem

and tighten bolts until handlebars

are securely in place.

2 Attach the left leg tube to

the other side of the rotational

connector. Using a 5mm Allen

wrench, slightly tighten bolt to

hold leg tube in place.

1 Using a 5mm Allen wrench,

remove the 2 bolts on the

handlebar clamp.

1 Insert the rotational connector

(A) into the right leg tube as

shown. Using a 5mm Allen

wrench, slightly tighten bolt to

hold connector (A) in place.

4 Insert the front fork into the rotational connector.

3 Adjust the rotational connector

so the opening is positioned as

shown.

5 Insert coupling bolt as shown and tighten using two (2) 5 mm Allen

wrenches until secure.

(A)