NOTE: The Trikke E2 must be traveling up to 3 mph before motor will engage. Kick start up to 3 mph while applying the throttle to engage motor. Owner’s Manual Read and understand this entire manual before allowing child to use this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice.
Contents Safety Warnings............................................................................................... 1 Before You Begin.............................................................................................. 2 Assembly and Setup......................................................................................3-4 Charging the Battery......................................................................................... 5 Pre-Ride Checklist/Usage................................
Before You Begin Remove contents from box. Remove the packaging separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the scooter is 50 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents. MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
ASSEMBLY and Set-up q Attaching the Handlebars Tools Required: 5mm Allen wrench 1 Using a 5mm Allen wrench, remove the 2 bolts on the handlebar clamp. 2 Center the handlebars onto the 3 Align the holes on the handlebar stem. Make sure the arc on the handlebars is facing outward and the arc of the stem is facing inward. clamp with the holes on the stem and tighten bolts until handlebars are securely in place.
ASSEMBLY and Set-up q Attaching the Stem Note: Make sure the cables/wires are out of the way before inserting the stem in the fork. Tools Required: 5mm Allen wrench WARNING: Failure to properly tighten the collar clamp may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.
charging the Battery q Charging the Battery Charge the battery prior to use. • Initial charge time: 12 hours. • Recharge time: up to 12 hours, even if the light turns green. Recommended maximum charging time is 24 hours. • Always charge the battery immediately after riding. • Fully charge battery before storing for extended periods of time. • Unplug charger from the wall outlet when not in use. • Failure to recharge battery periodically may result in a battery that will not accept a charge.
PRE-RIDE CHECKLIST q q q Brake Check the brakes for proper function. When you squeeze the lever, the brake should provide positive braking action. Make sure that brakes are not rubbing. Frame, Fork and Handlebars Check for cracks or broken connections. Although broken frames are rare, it is possible for an aggressive rider to run into a curb or wall and wreck, bend or break a frame. Get into the habit of inspecting your scooter on a regular basis.
USAGE q Learn and Practice Weight Distribution and Safety OPTIMAL RIDING POSITIONS Remember, it is the front wheel which mechanically powers the Razor Trikke E2. When accelerating, it is therefore important to place weight on the front wheel to maximize traction and control, as shown in the picture. Keep most of your weight on your toes, feet positioned in front of the platform. Note: The website of Trikke Tech, Inc., www.trikke.com, contains many useful videos and helpful tips. Trikke Tech, Inc.
USAGE DOWNHILL AND RIDER-ASSISTED RIDING The Razor Trikke E2 is intended to be primarily powered by its electric motor and does not “require” the rider to use the unique cambering practices associated with manually operated Trikke products for successful riding. The product may be operated to take some advantage of the those cambering principles, though, but riders are encouraged to practice these principles cautiously and carefully.
REPAIR AND MAINTENANCE Turn power switch “OFF” before beginning repair or maintenance: • Read the instructions • Remove Charger Plug • Turn the power switch off • Secure the unit under repair • Exercise caution around exposed parts • Contact Razor customer service if unsure about any repair or maintenance q Adjusting the Brakes Tools Required: 8mm wrench 1 To adjust the brake cable tension, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained.
REPAIR AND MAINTENANCE q Battery Care and Disposal Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery life, carefully read the “Charging the Battery” section on page 5 of this owner’s manual. CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally safe manner. Do not dispose of a lead-acid battery in a fire.
Trikke e2 Parts Keep your scooter running for years with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. Handlebar Grips 10. Battery Bracket 19. Motor Cover 2. Brake Lever Assembly 11. Battery Compartment (Left/Right) 20. Motor 3. Handlebar 12. On/Off Switch 21. Coupling Bolt 4. Handlebar Clamp 13. Charger Port 22. Rotational Connector Bolts (2) 5. Throttle 14. Chain Guard 23.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
DO NOT RETURN TO STORE Failure to follow these instructions may damage your product and void your warranty. Warranty Razor Limited Warranty The manufacturer warranties this product to be free of manufacturing defects for a period of 90 days from date of purchase. This Limited Warranty does not cover normal wear and tear, wheels, tubes, cables, or any damage, failure or loss caused by improper assembly, maintenance, or storage or use of the Razor Trikke E2. Razor does not offer an extended warranty.
