Instruction Manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

WARNING

Step 1

Step 2

Required Tool: (Not included)

A. Phillips screwdriver

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove six (6) screws from

the deck. Remove the deck from the unit and set aside.

Locate and disconnect the battery connector from the

controller.

C25/C25 SLA

CONTROLLER REPLACEMENT

C25 PART # W13113290015

C25 SLA PART # W13113291015

PAGE 1
C25/C25 SLA CONTROLLER REPLACEMENT C25 PART # W13113290015 C25 SLA PART # W13113291015 Required Tool: (Not included) A. Phillips screwdriver WARNING CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage. Step 1 Step 2 Using a Phillips screwdriver, remove six (6) screws from the deck.
PAGE 2
Step 3 Step 4 Using a Phillips screwdriver, remove two (2) screws from the controller bracket. Remove the bracket and controller from the unit and set aside. Continue to disconnect the rest of the connectors from the controller. Step 5 Reverse the steps. • Reattach the battery bracket on top of the battery. • Reconnect the battery to the controller. • Reposition the deck and attach with the screws that were removed in Step 1. ATTENTION: Charge battery 8 hours before using.