E Series Scooter Manual

q Chain and Rear Wheel Replacement
Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 13mm wrenches.
1 With a Phillips screwdriver,
loosen the two screws and
remove the chain guard.
2 Using two 13mm wrenches,
loosen the locknuts by turning
the wrenches counter clockwise.
3 To loosen the chain, push the
tensioner down to create some
slack in the chain.
1 Using a 10mm open wrench,
loosen the brake cable bolt.
q Front Wheel Replacement
Tools required: 10mm wrench, two (2) 17mm wrenches and a flathead screwdriver.
2 Using two 17mm wrenches,
loosen the locknuts by turn-
ing the wrenches counter
clockwise. Remove wheel and
install replacement wheel.
8-2
8-1
8-2
8-1
8-2
8-5
8-6
8-3
8-2
Right Side (Throttle)
8-3 - (Short) spacer
8-2 - Washer
Fork
8-2 - Washer
8-1 - 17mm locknut
Left Side (Brake)
8-5 - (Short) spacer
8-2 - Washer
Fork
8-2 - Washer
8-1 - 17mm locknut
Middle
8-6 - Front axle bolt
Note: Front wheel hardware
sequence
5
4 Remove wheel and install
replacement wheel.
(Note the sequence of the
hardware)
REPAIR AND MAINTENANCE
5 Push the chain tensioner
down to install the chain on
both sprockets.
6 With two 13mm wrenches,
re-tighten the locknuts.
Note: Rear wheel hardware
sequence
Right Side (Throttle)
18-1 M8 Nut
18-2 Washer (2)
Frame
18-3 Plate cut washer
18-4 (Short) Spacer
Left Side (Brake)
18-1 M8 Nut
18-2 Washer (2)
Frame
18-3 Plate cut washer
18-4 (Long) Spacer
7 Re-attach the chain guard.