Instruction Manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Paciﬁc Time.

WARNING

Step 1

Step 2

Required Tools: (Not included)

A. Phillips screwdriver

B. 4 mm Allen wrench

C. 8 mm wrench

D. Long nose needle pliers

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove the four (4) screws

on the deck cover. The locations of the screws are circled

in the image below.

Using a Phillips screwdriver and an 8 mm wrench, remove

the two (2) nuts and screws on the tail of the deck cover.

E100

, E200

, E300

Series

RESET BUTTON REPLACEMENT

INSTALLATION INSTRUCTIONS

PART # W151250011112

PAGE 1
E100®, E200®, E300® Series RESET BUTTON REPLACEMENT INSTALLATION INSTRUCTIONS PART # W151250011112 Required Tools: (Not included) A. Phillips screwdriver B. 4 mm Allen wrench C. 8 mm wrench D. Long nose needle pliers WARNING CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
PAGE 2
Step 3 Using a 4 mm Allen wrench, remove the two (2) hexagonal screws on the deck cover. The locations of the screws are circled in the image below. Remove the deck cover and set aside. Step 5 Locate and disconnect the battery from the controller before trying to disconnect the reset button. Step 4 Using a Phillips screwdriver, remove the four (4) screws on the battery holder. Locations of the screws are circled in the image below. Remove battery holder and set aside.
PAGE 3
Step 7 Using long nose needle pliers, disconnect the ring that holds the reset button to the battery tray. Step 8 Remove the reset button from the battery tray. Step 9 Reverse the steps to install new reset button. • Place the new reset button and secure it with the plastlc lock ring. • Reconnect the black and red wires that come from the battery, wires can be connected in any sequence onto the reset button prongs. • Reattach the battery holder on top of the battery.