TM Owner’s Manual Read and understand this entire manual before riding! Item Number: 155001
contents Safety Warnings..................................................................................1 Before You Begin..................................................................................2 Assembly and Set-Up....................................................................... 3-4 Repair and Maintenance.................................................................. 4-6 Troubleshooting Guide..................................................................... 7-8 Pocket Rocket Parts.
Before You Begin Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the Pocket Rocket was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
Assembly and Set-Up Charging the Battery Your electric motorbike may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. • Initial charge time: 12 hours • Run time: up to 40 minutes • Recharge time: up to 8 hours, • Average battery life: 250 charge/discharge cycles depending on the level of depletion Charger Port Charger Plug 2 Plug the charger plug into a wall outlet. 1 Plug the charger port into the port on the electric motorbike.
Assembly and Set-Up Inflating the Tires Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your purchase. Front Tire 1 Using a bicycle-style tire pump equipped for a Schradertype valve, inflate the front tire to the PSI indicated on the sidewall of the tire. Rear Tire 1 Remove valve extender/ 2 To inflate the rear tire align adapter from right handgrip. the access hole in the drive sprocket with the tire valve.
Repair and Maintenance q Chain and Rear Tire Replacement Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 1 Loosen screws and remove chain guard. 2 With a 10mm wrench, loosen the brake cable anchor and disconnect the cable. 3 With two 8mm wrenches, loosen brake housing anchor and disconnect. Keep the spacer and washers together. 4 Loosen and remove both axle adjuster nuts. 5 With two 17mm wrenches, loosen the axle.
Repair and Maintenance q Chain and Sprocket The chain will typically have a “loose spot” and “tight spot” corresponding with a particular sprocket rotational position. This is normal and common to all chain-driven vehicles due to run-out tolerances of the freewheel and sprocket. The chain should be adjusted to the ideal tension with chain in the tightest spot. Proper chain alignment must be maintained. The wheel must not be skewed.
Troubleshooting Guide Problem Vehicle does not run Possible Cause Solution Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the vehicle for the first time and up to 8 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on.
Troubleshooting Guide Problem Sometimes the vehicle doesn’t run, but other times it does Possible Cause Solution Check all wires around the motors and all connectors to make sure Loose wires or connectors they are tight. Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Charger gets warm during use Normal response to charger use No action required. This is normal for some chargers and is no cause for concern.
Pocket Rocket Parts Keep your Pocket Rocket running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.
Pocket Rocket Parts 10
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
Safety reminders PRE-RIDE CHECKLIST q q q Loose Parts There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Brake Check the brake for proper function. When you squeeze the lever, the brake should provide positive braking action. Frame, Fork and Handlebars Check for cracks or broken connections.
