Troubleshooting guide

10
Sometimes the vehicle
doesn’t run, but other times
it does
Charger gets warm during
use
Vehicle does not stop when
applying the brake
Vehicle makes loud noises
or grinding sounds
Problem Possible Cause Solution
Loose wires or connectors
Motor or electrical switch damage
Normal response to charger use
Brakes are not adjusted properly
Chain adjustment is too tight or too
loose
Chain is too dry
Brake rotor is dragging on brake pads
(Rebellion Electric Chopper only)
Check all wires around the motors and all connectors to make sure they are
tight.
Contact your local Razor authorized service center for diagnosis and repair.
No action required. This is normal for some chargers and is no cause for
concern. If your charger does not get warm during use, it does not mean that
it is not working properly.
Refer to adjusting the brakes instructions on page 4 to properly adjust
brakes.
Refer to instructions on page 5 and 6 of this manual to properly adjust chain
and sprocket.
Apply a lubricant such as WD-40® to the chain.
Use your fingers to twist the calliper adjuster in either direction until rotor is
centered between pads.
TROUBLESHOOTING GUIDE
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com
or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.