Operator`s manual

Coupler Systems

Figure 5: Lenz Coupler

Figure 6: Removing Pin

Figure 7: Pin

Your engine comes equipped with the Lenz coupler (See Below). Also included is the

Fine Scale European coupler.

To adjust the Lenz Coupler for more efficient operating of your locomotive while on

the track, you may have to change the length of the coupler. To do this, remove the pin

then slide the coupler forward or backward, then reinsert the pin into whichever slot

allows for better operation.

NOTE:

code used for the MTH Proto-Coupler. If your model came equipped with the

Lenz-style coupler DO NOT install an MTH Proto-Coupler without updating the

code. Like wise if your model came equipped with an MTH Proto-Coupler, DO NOT

install the Lenz-style coupler without updating the code. Damage may occur to the

coupler or the PS 3.0 board. You can change the code in the model if you desire to

change from one electrical style coupler to another. You will need a TIU running

software version 4.20 or higher and the Consumer Loader version 2.3 or higher.

The code used to operate the Lenz-style electrical couplers is different than the

Premier TRAXX Electric Engine