Operator`s manual

5. After repeating the procedure for the other motor, reassemble the chassis and body,

being careful that the wire harnesses are not caught between the chassis and body, and

reinstall the body mount screws.

Lubricate the outside truck block idler and drive gears with grease. Use the diagram

shown in Figure 10 below as a guide and add grease to the points marked.

Cleaning The Wheels, Tires, and Track

Periodically check the locomotive wheels and pickups for dirt and buildup, which can

cause poor electrical contact and traction and prematurely wear out the neoprene

traction tires. Wheels and tires can be cleaned using denatured (not rubbing) alcohol

applied with a cotton swab.

To clean the track, use RailKing® Track

Cleaning Fluid or denatured (not rubbing)

alcohol and a clean rag. Unplug the

transformer and wipe the rails of the track,

turning the rag frequently to ensure that you

are using clean cloth on the rails. Thereafter,

keep an eye on the track and clean it when it

gets dirty to ensure good electrical contact

and to lengthen the life of the tires.

Figure 10: Greasing The Idler Gears

Grease Idler Gears (G)

Premier TRAXX Electric Engine

Figure 11: Truck Side Screws

Truck Side Screws