Operator`s manual

DCC - Digital Command Control

DCC is a popular digital command scheme wherein the track power is also a digital

control signal. That is, using a DCC controller, you can communicate with multiple

engines and have all of them moving at different speeds and in varying directions on

the same track at the same time. The power/command signal remains constant and

engines are commanded to perform as desired. Your MTH PS3.0-equipped engine has

the ability to decode and respond to these DCC commands. This allows you to mix and

match MTH PS3—equipped engines as well as operate them with any other

manufacturer's DCC-decoder equipped engine. The best part about your MTH PS3.0-

equipped engine is that the decoder is built right in. No need to remove the hood and

install speakers or boards. It's all done for you at the factory. Each PS3.0-equipped

engine has a full complement of lights, sounds, smoke (if equipped). Just set the model

on the rails, apply DCC power and hit F3 on your DCC handheld controller and you're

off and running.

Switzerland & Germany (Engine without Train)

Front

Rear

red

Germany (Engine with Train)

Forward (Front) Forward (Rear) Reverse (Front) Reverse (Rear)

Switzerland (Engine with Train)

Premier TRAXX Electric Engine