OWNERS MANUAL Read and understand this entire manual before riding! Item Number 13114099
CONTENTS Safety Warnings ................................................................................ 1 Before You Begin ............................................................................... 2 Assembly and Set-Up ........................................................................ 3 Repair and Maintenance ................................................................ 4-5 Troubleshooting Guide ................................................................... 7-8 E500S Scooter Parts ...
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the E500S scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
ASSEMBLY AND SET-UP q Charging the Battery Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use. • Initial charge time: 12 hours • Run time: up to 40 minutes • Recharge time: up to 8 hours, • Average battery life: 250 charge/discharge cycles depending on the level of depletion Charger Port Charger Plug 2 Plug the charger plug into a 1 Plug the charger port into wall outlet. the port on the scooter.
ASSEMBLY AND SET-UP q Inflating the Tires Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your purchase. Note: The pressurized air supplies found at gasoline stations are designed to inflate high-volume automobile tires. If you decide to use such an air supply to inflate your scooter tires, first make sure the pressure gauge is working, then use very short bursts to inflate to the correct PSI.
REPAIR AND MAINTENANCE q Front Tire Replacement 1 Loosen front axle by attaching 10/15 mm wrenches to both axle nuts and loosening counter-clockwise. 2 Remove wheel and replace tire. To reinstall wheel, reverse these steps. q Rear Tire/Chain Replacement 1 Remove chain guard with Phillips Screwdriver. 2 Loosen rear axle by attach- 3 Remove wheel and replace ing wrenches to both axle nuts and loosening counter-clockwise. Pull chain off sprocket and remove wheel from frame. tire or chain.
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
TROUBLESHOOTING GUIDE Problem Scooter does not run Possible Cause Undercharged battery Solution Charge the battery. A new battery should have been charged for at least 12 hours before using the scooter for the first time and up to 8 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on.
TROUBLESHOOTING GUIDE Problem Sometimes the scooter doesn’t run, but other times it does Possible Cause Loose wires or connectors Solution Check all wires around the motors and all connectors to make sure they are tight. Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Charger gets warm during use Normal response to charger use No action required. This is normal for some chargers and is no cause for concern.
E500S PARTS Keep your E500S scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1. Front wheel with tire, tube, axle nuts 2. Rear wheel with tire, tube, sprocket, freewheel, axle nuts 3. Fork 4. Handlebar 5. Quill and handlebar clamp 6. Brake levers 7. Speed control 8. Seat mast w/screws 9. Chainguard w/screws 10. Sprocket and freewheel 11. Chain 12.
E500S PARTS 1 7 5 4 3 22 16 6 23 25 14 21 15 8 13 17 11 20 12 24 9 10 2 18 19 10
SAFETY REMINDERS PRE-RIDE CHECKLIST q Loose Parts q Brake q Check and secure all fasteners before every ride. Make sure steering stem clamp bolts are locked properly in place. There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Check the brake for proper function. When you squeeze the lever, the brake should provide positive braking action.
