Owner's manual

7
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
1 To adjust the tension, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
2 If the brake has too much slack,
use a 10 mm wrench to loosen the
brake anchor cable for additional
adjustment and retighten.
WARNING:
The brake is capable of causing the
electric motorbike to skid the tire,
throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control or damage the rear tire.
Note: The brake lever contains a
safety switch to cut power to the
motor when the brake is applied. In
an emergency, applying the brake
will always stop the product from
moving. Do not disable or replace
this lever with anything other than a
genuine Razor replacement part.
Testing the Brake
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fi tted with a cable
adjuster to compensate for cable stretch and/or to fi ne-tune the lever movement to engage the brake. If brake is
not engaging properly, follow instructions for adjusting the brake outlined below.
Adjusting the Brake
Tool Required: 10 mm Wrench
Starting the Dirt Rocket
Place both hands on the handlebars. Slowly push forward with one foot and
apply the throttle.
Note: Keep both feet on the foot pegs when unit is in motion.
Stopping the Dirt Rocket
Release the throttle and apply the brake.
Note: When coming to a complete stop, place both feet on the ground to
balance the unit.
REPAIR AND MAINTENANCE
USAGE
Turn power switch “OFF” before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
• Secure the unit under repair
• Exercise caution around
exposed parts
• Contact Razor customer service
if unsure about any repair or
maintenance