Owner's manual

4
ASSEMBLY AND SET-UP
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to lose
control and crash.
1 Place the handlebars in the
handlebar clamps.
2 Align parallel to the fork and
tighten the bolts using a 6 mm Allen
wrench. When properly tightened,
the handlebars should not move
forward or backward.
Align fender with the hole in the
fork and insert the bolt. Tighten
securely using a 10 mm wrench
and 5 mm Allen wrench.
Slip the cables through the slit on the
top of the number plate. Align the
number plate with the holes on the
fork and snap on the number plate.
Attaching the Handlebars
Tool Required: 6 mm Allen Wrench
Attaching the Front Fender
Tools Required: 10 mm Wrench and 5 mm Allen Wrench
Attaching the Number Plate
No tools required