Owner's manual

3
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
BEFORE YOU BEGIN
Front Fork
Brake Lever
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the
contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the
Dirt Rocket is 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a
few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 6 for charging information).
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
DIRT ROCKET. The Dirt Rocket
has been built to certain Razor
design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may not be compatible
and will void your warranty.
Required Tools
Throttle
Chain Guard
Charger
(Note: Charger design may vary
from one shown)
PRODUCT I.D. CODE
1. Underneath Frame
2. Charger
3. Battery Cover
4. UPC Side of Box (not shown)
Plastic Bag Contents:
• Charger
• Tools
• Handlebar Clamps
• Owner’s Manual
5 mm and 6 mm
Allen Wrenches
Spoke Tightener10 mm Wrench