TM OWNER’S MANUAL Read and understand this entire manual before riding! Item Number: Bistro 15130640
CONTENTS Safety Warnings ............................................................ 1 Before You Begin ........................................................... 2 Assembly and Set-Up .................................................... 3 Repair and Maintenance ............................................. 4-6 Troubleshooting Guide................................................ 7-8 Pocket Mod Parts ..................................................... 9-10 Safety Reminders .............................
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the Pocket Mod was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
ASSEMBLY AND SET-UP Charging the Battery Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. • Initial charge time: 12 hours • Run time: up to 40 minutes • Recharge time: up to 8 hours • Average battery life: 250 charge/discharge cycles depending on the level of depletion WARNING: Always disconnect your Pocket Mod from the charger before cleaning with liquid.
REPAIR AND MAINTENANCE Check the Razor web site for any updates on the latest repair and maintenance procedures. Turn power switch off before conducting any maintenance procedures. ❑ Adjusting the Brakes 1 To adjust the play, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2.
REPAIR AND MAINTENANCE ❑ Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 1 With a Phillips screwdriver, 2 With a 10mm wrench, loosen 3 the brake cable anchor and disconnect the cable. With two 8mm wrenches, loosen brake housing anchor and disconnect. Keep the spacer and washers together. 4 With two 17mm wrenches, loosen the axle. Push the wheel forward in the slots to loosen the chain. 5 Pull the wheel out.
REPAIR AND MAINTENANCE ❑ Battery Care and Disposal Do not store the battery in temperatures above 75° or below -10° F. CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a lead-acid battery in your regular household trash.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Vehicle does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the vehicle for the first time and up to 8 hours after each subsequent use. Check all connections. Make sure the charger port is tightly plugged into the charging port on the Pocket Mod, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Sometimes the vehicle Loose wires or connectors doesn’t run, but other times it does Motor or electrical switch damage Check all wires around the motors and all connectors to make sure they are tight. Charger gets warm during use No action required. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.
POCKET MOD PARTS Keep your Pocket Mod running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.
POCKET MOD PARTS 10
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
SAFETY REMINDERS PRE-RIDE CHECKLIST ❑ Loose Parts ❑ Brake ❑ Frame, Fork and Handlebars There should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an experienced mechanic to check. Check the brake for proper function. When you squeeze the lever, the brake should provide positive braking action. When you apply the brake with the speed control on, the brake cut-off switch will stop the motor.
