Owner`s manual

ASSEMBLY AND SET-UP
q Attaching the Handlebars
q Charging the Battery
Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery
prior to use.
2 Turn power OFF before
charging. Plug the charger into
the charger port on the electric
scooter.
Charger
Charger
Plug
Charger
Port
2
With the front wheel pointed
straight ahead and the handlebars
square to the front wheel, tighten
the clamp as shown. Tighten
securely.
1 Loosen the collar clamp and
slide it upward. With a clock-wise
twisting motion, push and “thread”
the steering tube onto the fork until
it bottoms out on the fork headset
lock nut.
Note: Make sure any cables/
wires are out of the way before
inserting the stem into the fork.
WARNING: Failure
to recharge the battery at least
once a month may result in
a battery that will no longer
accept a charge.
WARNING: Always
disconnect your scooter from
the charger before cleaning with
liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED to indicate the
charge status. Refer to the
illustration on the charger unit
for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-
charge protection to prevent
battery from being over-charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause for
concern. If your charger does
not get warm during use, it does
not mean that it is not working
properly.
q Attaching the Handlebar Grip
WARNING: Failure to
properly engage the spring-loaded
button may cause the handlebar
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged, the
handlebar will not rotate nor will
it move sideways. Note that when
properly engaged, the spring-loaded
button is clearly visible in the hole
on the T-tube.
2
Make certain the spring-loaded
button engages the hole and is
properly locked into the T-bar.
1
Insert and secure the collaps-
ible handlebar by pressing the
spring-loaded button and
inserting it into the T-bar.
1 Plug the charger into a wall
outlet. If the lights on charger
do not light up, check the power
to the outlet. If necessary, try a
different outlet.
•Initialchargetime:12hours
•Rechargetime:upto12hours,
even if the light turns green.
•Fullychargebatterybeforestoring.
•Whenthescooterisnotinregularuse,
recharge the battery at least once a
month until normal use is resumed.
•Makesurepoweristurned OFF when
unit is not in use.
•Runtime:Upto40minutesofcontinuousridetime.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
•Constantstoppingandstartingmayshortenridetime.
•Averagebatterylifeforapoperlymaintainedunitis
approx. 250 charge/discharge cycles.
• Toensurelongbatterylife,neverstoretheproductin
freezing or below freezing temperatures! Freezing will
permanently damage the battery. Failure to recharge
the battery at least once a month may result in a
battery that will no longer accept a charge.
•Continuechargingforthefull12hourseven
if charge light indicates charging complete.